COLD PAINT APPLICATION (ATOMIZING AIR)
From city areas to urban and interurban roads, the Borum Master 2500 can handle both smaller jobs and longer road stretches. The Borum Master 2500 is an agile machine with excellent load abilities. Equipped with the Borum LineMaster computer, operating the machine is easy and convenient.The BM 2500 has a one-seat slidable drive and operator section for flexible working on left or right side. Easy access and servicing of the machine through large doors to the engine room. The machine can be equipped to execute lines in widths between 8-40cm (~50cm). The equipment may be used for the application of single and double lines of different widths, as well as for the simultaneous application of continuous and interrupted lines.
Line types that can be applied with this equipment
Pressurized black steel tank for solvent - based cold paint.The material tank has a filling system with large filling holes. This makes the filling process very easy to manage. In addition, the large filling holes also make cleaning the tanks easy.Agitator (mixer) Driven by hydraulic motor and with manually operated reversing valve.
Air spray with atomizing air is a method of marking that uses a pressure tank for the material and compressed air to atomize and spray the paint onto the road surface. For all Borum spray machines, the equipment is mounted on a sliding retainer frame as standard that allows you to quickly slide the equipment from one side to another. You can have 1-3 paint guns, depending on the set-up of the machine, and 1-3 bead guns are attached.The ground distance is maintained by a retainer wheel to ensure a constant road marking width. Lifting of retainer is pneumatic and done from the operator's seat. Paint filter with cut-off valve for easy maintenance. The machine can be equipped with two material tanks so that dual-color marking can be carried out simultaneously. Working speed can be up to 15 km/h depending on the conditions, e.g. material, line type, and operator experience.
High-performance spray gun. with a 6 mm nozzle set for water-based, solvent-based and high solid paints. The BM C 6 gun can work with paint marking pressure up to approx. 8 bar.Air capacity of 300-700 L/min. is needed per gun.Possibility to apply lines in widths from 8 to 20 cm with one gun depending on work conditions, nozzle size, application speed, and layer thickness. Line thickness is typically between 0.25 mm to 0.80 mm.
Cold paint material is a cost-effective solution for executing flat markings over all types of pavements and for use in repairments. Flat lines are mainly used in well-illuminated areas as urban roads for e.g. where the lines do not need high retroreflectivity levels. Although drying time different between types of paints, it is usually quite long and cones and traffic management might be needed.
10L pressure solvent tank for cleaning of hoses and paint guns.
The Borum LineMaster control unit is an easy way of setting and controlling your line marking jobs. The LineMaster is attached to the operator's section of the machine and gives you full control of all your line marking tasks, from line application and pre-marking to reporting and invoicing. It is possible to store up to 99 different line types, and to arrange these in up to 30 different marking programs. You are also able to pre-set line widths, line types and different combinations to have them ready for marking, and can instantly adjust them on the go.Furthermore, you are able to view the status of various parts of the machine (e.g. compressor) on the computer screen that will help with correctly maintaining the machine and avoiding break downs.